top of page
Hipster with Camera

BlackBox 135 for 35mm film

In The Box

- Light Table

- USB-A Power Cable 

- Height Extension Sections with bayonet lock: 100mm, 50mm, 35mm, 30mm, 25mm, 20mm 

- Lens Mounting Sections 

- Set of step-up filter rings: 67mm, 62mm, 58mm, 55mm, 52mm, 49mm, 37mm 

- 35mm Film Carrier

- Mounted Slides Carrier 

How To Use

1. Connect the power cable to the light table and a power source. 

2. Open the flap of the film carrier and place a film negative stripe in the grooves. Close the film carrier flap. 

3. Insert the film carrier into the light table through an opening on either side. 

4. Attach height extension sections to the top of the light table using the bayonet lock. To connect the height extension section insert one section into another and rotate clockwise to lock. Extension sections of different heights can be stacked in any order. 

5. Attach the lens mount section to the top height extension section. 

6. Unscrew all step-up filter rings that are smaller than the filter thread diameter of your lens. Screw the remaining set of step-up filter rings to your lens. 

7. Place your lens on the top of the lens mount section facing down. The 67mm step-up ring will tightly fit into the lens mount section. 

8. Activate the illumination light with the switch on the power cable. 

9. Focus your lens on the surface of the film. 

10. Check your framing: you want the film frame to fill your digital sensor as much as possible. If necessary, adjust the distance between your lens and the film using a different combination of extension sections (step 4). 


Light Table

Material - ABS, PLA, stainless steel

Net Weight - 93g

Footprint - 107mm x 87mm x 43mm 

Number of LEDs - 42 

Color Rendering Index (CRI) - 95 

Color Temperature - 6500K 

Illuminance - 10cm, 6392lux 

Brightness levels - 10 

Power consumption - 7.5W 

Required Power Source - USB, 5V, 2A 

Power input - Micro A USB 

Power cable - USB-A, 1.5m 

Film Carrier

Holds - 6 frames strip of 35mm (135-type) film 

Net Weight - 35g 

Dimensions - 275mm x 52mm x 4.7mm 

Slides Carrier

Holds - 2 mounted slides of 35mm (135-type) film 

Net Weight - 16g 

Dimensions - 155mm x 52mm x 4.7mm 

Slides Carrier

Material - PLA

Dimensions - ID=60mm, OD=80mm, H=100mm, 50mm, 35mm, 30mm, 25mm, 20mm 

bottom of page